:	Jun 15, 2004

:

The receiver drier need only be changed under the following circumstances: There is dirt in the refrigerant circuit ( eg. compressor seizure ). The system is leaking and refrigerant has been lost to atmosphere. Refrigerant circuit has been open more than 24 hours due to repair.

.

Disconnect the battery ground cable.

.

Remove the condenser core.

.

Remove the receiver drier support bracket clamp.   Remove the bolt.

.

: Immediately cap all refrigerant lines to prevent ingress of dirt and moisture. Remove the receiver drier.   Remove the bolt.   Remove and discard the 2 O-ring seals.

.

Install the receiver drier.   Clean the component mating faces.   Install new O-ring seals.   Install the clamp.   Tighten the bolts to 10 Nm (7 lb.ft).

.

Install the condenser core.

.

Connect the battery ground cable.